VUE FWD L4-2.4L Hybrid (2007)
5. Remove the RDM bracket-to-bushing mounting nut and bolt.
6. Remove the nut (1) and bolt (3) from the mounting RDM mounting bracket (2) and remove the bracket.
7. Place the open receiver end of the J 44866 over the flanged side of the bushing and against the vehicle frame.
8. Position the driver portion of the J 44866 with the smaller diameter of the driver against the bushing.
9. Install the bolt and washer through the driver, bushing, and receiver
10. Install the nut to the bolt.
11. Slowly tighten the bolt and nut until the bushing is driven out of the vehicle frame and into the receiver.
12. Disassemble the J 44866 and remove the bushing.
Installation Procedure