VUE FWD V6-3.5L (2008)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Brake Pressure Modulator Valve Replacement
Brake Pressure Modulator Valve Replacement
Removal Procedure
Caution: Refer to Brake Fluid Irritant Caution (See: Service Precautions/Technician Safety Information/Brake Fluid Irritant Caution) .
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice (See: Service Precautions/Vehicle Damage Warnings) .
Notice: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to
observe this precaution could result in damage to the EBCM/EBTCM.
1. Turn the ignition switch to the OFF position.
2. Remove the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement (See: Maintenance/Fuses and
Circuit Breakers/Fuse Block/Service and Repair/Underhood Electrical Center or Junction Block Replacement) .
3. Disconnect the electronic brake control module (EBCM) electrical connector by lifting the locking tabs.
4. Disconnect the LF brake pipe fitting (1) at the brake pressure modulator valve (BPMV).
Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
5. Disconnect the RF brake pipe fitting (2) from the BPMV.
Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
