VUE FWD V6-3.5L (2008)
6. Remove the brake rotor screw (1) and the brake rotor.
7. If the brake rotor is to be machined, check the thickness variation measurement. Refer to Brake Rotor Thickness Variation Measurement (See:
Testing and Inspection/Brake Rotor Thickness Variation Measurement) .
Installation Procedure
1. If installing a new brake rotor, clean the friction surfaces of the brake rotor with denatured alcohol.
2. Using the J 42450-A , thoroughly clean any rust or corrosion from the mating surface of the hub/axle flange.
3. Using the J 41013 , thoroughly clean any rust or corrosion from the mating surface of the rotor to the hub/axle flange.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
4. Install the brake rotor.
If installing the original brake rotor, align the rotor to the wheel hub as noted during removal.
5. Install the brake rotor screw (1).
Tighten the screw to 10 N.m (89 lb in).
