VUE FWD V6-3.5L (2008)
7. Connect the LF brake pipe fitting (1) to the BPMV.
Tighten the fitting to 21 N.m (16 lb ft).
8. Connect the RF brake pipe fitting (2) to the BPMV.
Tighten the fitting to 21 N.m (16 lb ft).
9. Connect the EBCM electrical connector.
10. Install the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement (See: Maintenance/Fuses and Circuit
Breakers/Fuse Block/Service and Repair/Underhood Electrical Center or Junction Block Replacement) .
11. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) (See: Brake Bleeding/Service and Repair)Hydraulic Brake
System Bleeding (Pressure) (See: Brake Bleeding/Service and Repair) .
12. Turn the ignition switch to the ON position.
13. Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) .
14. Observe the brake pedal feel after performing the diagnostic system check. If the pedal now feels spongy, air may have been in, or may have been
introduced into the primary circuit.
If the pedal feels spongy, perform the Antilock Brake System Automated Bleed Procedure (See: Brake Bleeding/Service and Repair) .
