VUE FWD V6-3.5L (2008)
Fuel Pump Control Unit: Customer Interest
Fuel System - MIL ON/DTC P2635 Set
TECHNICAL
Bulletin No.: 08-06-04-021
Date: March 19, 2008
Subject:
Malfunction Indicator Lamp (MIL) - Check Engine Light On, DTC P2635 Set (Reprogram Fuel Pump Control Module (FPCM))
Models:
2008 Saturn VUE
with 3.5L V6 Engine (VIN N - RPO LZ4)
Condition
Some customers may comment that the check engine light is on.
Upon investigation, the technician may find DTC P2635 set as current or history in the fuel pump control module (FPCM).
Correction
Review "Ignition 1 Signal" voltage in the Freeze Frame Data using the Tech 2(R).
^
If the "Ignition 1 Signal" is greater than 14.8 volts, this code is likely set due to a calibration error. An updated calibration for the FPCM has been
released to address this concern. This new calibration will ensure proper fuel pressure is maintained through the full range of system voltage.
Reprogram the FPCM with updated calibration files using the TIS2WEB Service Programming System (SPS) application. As always, make sure your
Tech 2(R) is updated with the latest software version.
^
If the "Ignition 1 Signal" is less than 14.8, volts refer to published SI diagnostics.
Clear the P2635 from the FPCM and the associated P069E from the ECM.
Warranty Information
For vehicles repaired under warranty use, the table.
Disclaimer
