VUE FWD V6-3.5L (2008)
1. Lubricate a NEW fuel pressure sensor O-ring seal with clean engine oil.
2. Install the NEW fuel pressure sensor O-ring seal (2) onto the fuel line fitting.
3. Wrap a shop towel around the fuel pressure sensor fitting in order to absorb any fuel that may leak out.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
4. Install the fuel pressure sensor (1) to the fuel line.
Tighten the sensor to 15 N.m (11 lb ft).
5. Connect the body wiring harness electrical connector (1) to the fuel pressure sensor (2).
6. Lower the vehicle.
7. Use the following procedure in order to inspect for leaks:
1. Turn the ignition ON, with the engine OFF, for 2 seconds.
2. Turn the ignition OFF for 10 seconds.
3. Turn the ignition ON, with the engine OFF.
