VUE FWD V6-3.5L (2008)
4. Position the LF brake pipe to the BPMV.
5. Connect the LF brake pipe fitting (1) to the BPMV.
Tighten the fitting to 21 N.m (16 lb ft).
6. Install the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement (See: Maintenance/Fuses and Circuit
Breakers/Fuse Block/Service and Repair/Underhood Electrical Center or Junction Block Replacement) .
7. If installing a new EBCM, program the EBCM. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) .
8. Without starting the engine, place the ignition switch in the ON position.
9. Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) .
10. Observe the feel of the brake pedal after performing the diagnostic system check. If the pedal now feels spongy, air may have been in the
secondary circuit of the brake modulator assembly, which may have been introduced into the primary circuit.
If the pedal feels spongy, perform the Antilock Brake System Automated Bleed Procedure (See: Brakes and Traction Control/Brake
Bleeding/Service and Repair) .
