VUE FWD V6-3.5L (2008)
14. Install the retaining clip (10) onto the coded lock cylinder where it comes out of the back of the lock cylinder housing (5).
15. Install the trim cap (4) on the ignition lock assembly.
Ignition Lock Cylinder - EPS
The ignition lock cylinder used 7 of the 10 key cut positions, 4-10 when counting from the key head. The tumbler (3) orientations alternate in adjacent
locations from side to side with 3 on one side and 4 on the other.
Caution: Wear safety glasses in order to avoid eye damage.
Important: The ignition lock cylinder tumblers (3) are not self-retaining and must be held in place if the key is not fully inserted into the
lock cylinder.
1. Hold the uncoded cylinder plug (5) positioned so the side with the sidebar slot is facing to the left and the 3 spring holes are on top.
2. Insert one tumbler spring (7) each into the 3 tumbler spring holes.
3. The first tumbler to be loaded will be key cut position number 5, the fifth number in the key code. Determine the cut depth at this position and
install the corresponding tumbler (8) into the tumbler slot second from the front of the cylinder plug (5) (the end where the key is inserted).
