VUE FWD V6-3.5L (2008)
7. Use installer J 44015 to seat the steering linkage outer tie rods.
Tighten installer J 44015 to 40 N.m (30 lb ft)
8. Install the steering linkage outer tie rod nuts (1).
Tighten the nuts to 25 N.m (18 lb ft) plus 90 degrees.
9. Clean any excess fluid from the vehicle and remove the drain pans if equipped with HPS.
10. Fill and bleed the power steering system if equipped with HPS. Refer to Power Steering System Bleeding (See: Power Steering/Power Steering
Bleeding/Service and Repair)
11. Install the front tire/wheel assemblies. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair) .
12. Adjust the front toe. Refer to Front Toe Adjustment (See: Alignment/Service and Repair/Front Toe Adjustment) .
