VUE FWD V6-3.6L Hybrid (2009)
4. Rotate the drive motor generator control module assembly onto the APM.
5. Clamp the GE-48494 - adapter kit components (2, 3) to a coolant pipe.
6. Plug the remaining coolant pipe with the GE-48494 - adapter kit plug and clamp (1).
7. Apply 20 psi (138 kPa) pressure with J 24460-01 - pressure tester (4).
8. Monitor the pressure tester gauge for 5 minutes and ensure that pressure remains at the specified value.
*
If the specified pressure cannot be maintained, disassemble the drive motor generator control module assembly and replace the coolant seals.
*
If pressure remains at the specified value, proceed to the next step.
9. Remove all GE-48494 - adapter kit components.
10. Remove the PIM cover bolts (1).
11. Remove the PIM cover (2).
