VUE FWD V6-3.6L Hybrid (2009)
3. Test for less than 3 ohms between the following terminals:
*
The terminal 6 and the line hot terminal
*
The terminal 3 and the line neutral terminal
‹› If greater than the specified range, replace the accessory power outlet.
4. Test for infinite resistance between terminal 4 and terminal 1.
‹› If not the specified value, replace the accessory power outlet.
5. Connect an AC powered device to the accessory power outlet.
6. Test for less than 3 ohms between terminal 4 and terminal 1.
‹› If greater than the specified range, replace the accessory power outlet.
7. Test for 2.9-3.1 volts, with the DMM set on the diode setting and the positive test lead to terminal 6 and the negative test lead to terminal 3.
‹› If not within the specified range, replace the accessory power outlet.
8. Test for 0.0-0.1 volts, with the DMM set on the diode setting and the positive test lead to terminal 3 and the negative test lead to terminal 6.
‹› If greater than the specified range, replace the accessory power outlet.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/Verification Tests and Procedures) after completing the diagnostic procedure.
*
120-Volt Accessory Power Receptacle Replacement (See: Service and Repair/120-Volt Accessory Power Receptacle Replacement)
*
Control Module References (See: Testing and Inspection/Programming and Relearning) for control module replacement, setup, and programming
