xA L4-1.5L (1NZ-FE) (2006)
Trunk / Liftgate Shock / Support: Service and Repair
BACK DOOR SUPPORT
REMOVAL
HINT:
-
Use the same procedure for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. REMOVE BACK DOOR STAY ASSEMBLY LH
(a) Remove the 2 bolts and stay from the door panel.
HINT: Remove the door stay while supporting the back door with your hands.
(b) Remove the 2 bolts and stay from the body panel.
INSTALLATION
HINT:
-
Use the same procedure for the RH side and LH side.
-
The procedures listed below are for the LH side.
-
A bolt without a torque specification is shown in the standard bolt chart.
1. INSTALL BACK DOOR STAY ASSEMBLY LH
(a) Install the stay with the 4 bolts.
Torque: 8.0 Nm (82 kgf-cm, 71 in.-lbf)
DISPOSAL
HINT: Use the same procedure for the RH side and LH side.
1. DISPOSE OF BACK DOOR STAY ASSEMBLY LH
(a) Horizontally fix the stay in a vise with the piston-rod pulled out.