xA L4-1.5L (1NZ-FE) (2006)
NOTE
^
If vehicle requires only ONE calibration update, then proceed to step N in this bulletin.
^
If vehicle requires a SECOND calibration update, then continue as follows:
^
For serial communication vehicles, go to step J.
^
For CAN communication vehicles, go to step L.
J. When Cal 1 has completed the update process turn ignition OFF for a minimum of 10 seconds. Then click Next.
K. Turn ignition to the ON position. Then click Start.
NOTE
If key cycle is NOT done properly, reprogramming will stop at 10% and Cal 2 will fail to load.