xA L4-1.5L (1NZ-FE) (2006)
-
The procedures listed below are for the LH side.
1. INSTALL FRONT SPEED SENSOR LH
a. Install the speed sensor with the bolt.
Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
NOTE: Keep the sensor tip and sensor installation hole free from foreign matter.
b. Install the speed sensor wire harness to the body and shock absorber with the 2 clamp bolts.
Torque:
8.0 N.m (82 kgf.cm, 71 in.lbf) for bolt A
29 N.m (300 kgf.cm, 21 ft.lbf) for bolt B
NOTE: Do not twist the sensor wire when installing it.
c. Connect the resin clip and speed sensor wire harness to the shock absorber.
NOTE: Do not twist the sensor wire when installing it.
d. Connect the speed sensor connector.
NOTE: Do not twist the sensor wire when installing it.
2. INSTALL FRONT WHEEL
Torque: 103 N.m (1,050 kgf.cm, 76 ft.lbf)
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL