xA L4-1.5L (1NZ-FE) (2006)
c. Install a new lock washer and tighten the manual valve shaft nut.
Torque: 6.9 Nm (70 kgf-cm, 61 inch lbs.)
d. Temporarily install the control shaft lever.
e. Turn the lever counterclockwise until it stops, and then turn it clockwise 2 notches.
f.
Remove the control shaft lever.
g. Align the groove with neutral basic line.
h. Hold the switch in this position and tighten the 2 bolts.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
i.
Using a screwdriver, stake the nut with the lock washer.