xB L4-1.5L (1NZ-FE) (2004)
/Page-1332001.png)
Tail Lamp: Service and Repair
REAR COMBINATION LAMP ASSY LH
OVERHAUL
1. REMOVE REAR COMBINATION LAMP SERVICE COVER LH
2. REMOVE REAR COMBINATION LAMP ASSY LH
a. Disconnect the connector.
b. Remove the 2 nuts and the rear combination lamp assy LH.
3. REMOVE REAR COMBINATION LAMP BODY GASKET LH
4. REMOVE REAR COMBINATION LAMP BULB
a. Remove the 3 rear combination lamp bulbs and 3 rear combination lamp socket and wire sub-assy as shown in the illustration.
b. Remove the 3 rear combination lamp bulbs from the 3 rear combination lamp socket and wire sub-assy.
5. REMOVE REAR COMBINATION LAMP SOCKET AND WIRE SUB-ASSY LH
6. REMOVE REAR COMBINATION LAMP SOCKET AND WIRE SUB-ASSY LH
7. REMOVE REAR COMBINATION LAMP SOCKET AND WIRE SUB-ASSY LH
8. REMOVE REAR COMBINATION LAMP LENS LH
a. Using a screwdriver, disengage the 11 claws and rear combination lamp lens LH.
9. REMOVE REAR COMBINATION LAMP LENS GASKET LH
10. REMOVE REAR COMBINATION LAMP LENS & BODY LH
11. INSTALL REAR COMBINATION LAMP LENS LH
a. Install the new rear combination lens gasket on the rear combination lamp lens & body LH.
b. Install the rear combination lamp lens LH an the rear combination lamp lens & body LH.
NOTE:
