xB L4-1.5L (1NZ-FE) (2004)
d. Temporarily install the control shaft lever.
e. Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.
f.
Remove the control shaft lever.
g. Align the groove with neutral basic line.
h. Hold the switch in this position and tighten the 2 bolts.
Torque: 5.4 Nm (55 kgf-cm, 48 in. lbs.)
i.
Using a screwdriver, stake the nut with the lock plate.
j.
Install the control shaft lever, washer, and nut.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
k. Connect the connector to the park/neutral position switch assy.