xB L4-1.5L (1NZ-FE) (2004)
25. INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH
a. Install the rear brake assembly and the rear axle hub & bearing assembly LH with the 4 bolts.
Torque: 63 Nm (642 kgf-cm, 46 ft. lbs.)
26. INSTALL REAR AXLE HUB & BEARING ASSEMBLY RH
HINT: Installation of the RH is the same as that of the LH.
27. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
28. ADJUST REAR DRUM BRAKE SHOE CLEARANCE
29. CONNECT PARKING BRAKE CABLE ASSEMBLY NO.3
30. CONNECT PARKING BRAKE CABLE ASSEMBLY NO.2
HINT: Removal of the RH is the same as that of the LH
31. CONNECT REAR BRAKE TUBE NO.4
SST 09023-00100
32. CONNECT REAR BRAKE TUBE NO.3
SST 09023-00100
HINT: Removal of the RH is the same as that of the LH
33. CONNECT SKID CONTROL SENSOR WIRE
34. FULLY TIGHTEN REAR AXLE BEAM ASSEMBLY
Torque: 82 Nm (836 kgf-cm, 60 ft. lbs.)
35. FULLY TIGHTEN SHOCK ABSORBER ASSEMBLY REAR LH
36. FULLY TIGHTEN SHOCK ABSORBER ASSEMBLY REAR RH
HINT: Removal of the RH is the same as that of the LH.
37. BLEED BRAKE LINE
38. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
39. INSPECT REAR WHEEL ALIGNMENT
40. CHECK ABS SPEED SENSOR SIGNAL