xB L4-2.4L (2AZ-FE) (2009)
(a) Remove the stop light switch.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
(c) Reinstall the stop light switch.
NG -- REPLACE STOP LIGHT SWITCH
OK -- Continue to next step.
4. CHECK HARNESS AND CONNECTOR (STOP FUSE - STOP LIGHT SWITCH)
(a) Disconnect the A1 stop light switch connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard voltage:
(c) Reconnect the stop light switch connector.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
5. CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH - REAR STOP LIGHT)