xB L4-2.4L (2AZ-FE) (2009)
(a) Disconnect the C17 center airbag sensor assembly connector.
(b) Measure the resistance according to the value(s) in the table below.
HINT: The resistance must be measured after the C48 CAN center junction connector is disconnected.
Standard Resistance:
NG -- REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO CENTER AIRBAG SENSOR ASSEMBLY (CAN-H,
CAN-L)
OK -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY
21. CHECK CAN BUS LINE FOR SHORT TO +B (MAIN BODY ECU BRANCH WIRE)