xB L4-2.4L (2AZ-FE) (2009)
/Page-818035.png)
(a) Disconnect the C26 accessory bus buffer connector.
(b) Measure the resistance according to the value(s) in the table below.
HINT: The resistance must be measured after the C48 CAN center junction connector is disconnected.
Standard Resistance:
NG -- REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO ACCESSORY BUS BUFFER
OK -- CHECK ACCESSORY CIRCUIT
23. CHECK CAN BUS LINE FOR SHORT TO +B (ECM MAIN WIRE)
