xB L4-2.4L (2AZ-FE) (2009)
Knock Sensor: Service and Repair
Installation
2AZ-FE ENGINE CONTROL SYSTEM: KNOCK SENSOR: INSTALLATION
INSTALLATION
1. INSTALL KNOCK SENSOR
(a) Install the knock sensor with the nut.
Torque: 20 Nm (205 kgf-cm, 15 ft-lbf)
(b) Connect the sensor connector.
2. INSTALL NO. 1 INTAKE MANIFOLD INSULATOR
(a) Install the No. 1 intake manifold insulator.
3. INSTALL INTAKE MANIFOLD
(a) Install a new gasket into the intake manifold.
(b) Install the intake manifold with the 5 bolts and 2 nuts.
Torque: 30 Nm (306 kgf-cm, 22 ft-lbf)
(c) Install the wire harness clamp onto the intake manifold.