xB L4-2.4L (2AZ-FE) (2009)
E. Confirm the following:
^
PC is connected to VIM.
^
VIM is connected to DLC3 connector.
^
Ignition is ON and engine is OFF.
Then click Next.
F. Verify correct current calibration and new calibration information. Then click Next.
NOTE
^
The total number of calibration IDs in the calibration file corresponds to the number of reprogrammable processors in the ECU.
^
Each calibration file may contain up to three separate calibrations.
^
Figure 17 shows an example of the update procedure for a two-processor ECU.