scion Workshop Repair Guides

Scion Workshop Service and Repair Manuals

Center Airbag Sensor Assembly|Page 6028 > < Center Airbag Sensor Assembly|Page 6026
Page 3
background image

(a) Confirm that the ignition switch is turned to OFF.
(b) Confirm that the negative battery terminal is detached.

CAUTION:
-

Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag
sensor will cause the airbag to deploy.

-

Do not start the operation for at least 90 seconds after disconnecting the negative battery terminal.

(c) Install the 3 bolts and remove the airbag sensor.

Torque: 18 Nm (178 kgf-cm, 13  ft-lbf)

NOTICE:
-

Do not use an airbag sensor that has been dropped.

-

Do not subject the airbag sensor to any impact or force.

-

Confirm that the carpet does not interfere with the installation plane.

(d) Confirm that there is no looseness by shaking the front airbag sensor.

(e) Connect the connector holder to lock the lever.

NOTICE:  Confirm that the lever is locked.

(f) Confirm that the drip-proof sheet has not been removed and does not cut into the connectors.

2. INSTALL SHIFT LEVER ASSEMBLY (for Automatic Transaxle) See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shifter

A/T/Service and Repair/Removal and Replacement/Installation

3. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY (for Automatic Transaxle) See: Transmission and Drivetrain/Automatic

Transmission/Transaxle/Shifter A/T/Service and Repair/Removal and Replacement/Installation

4. INSPECT SHIFT LEVER POSITION (for Automatic Transaxle) See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shifter

A/T/Testing and Inspection/U241E Automatic Transaxle/On-Vehicle Inspection

5. ADJUST SHIFT LEVER POSITION (for Automatic Transaxle) See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shifter

A/T/Service and Repair/Removal and Replacement/Installation

6. INSTALL SHIFT LEVER ASSEMBLY (for Manual Transaxle) See: Transmission and Drivetrain/Manual Transmission/Transaxle/Shifter

M/T/Service and Repair/Installation

7. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY (for Manual Transaxle) See: Transmission and Drivetrain/Manual

Transmission/Transaxle/Shifter M/T/Service and Repair/Installation

Center Airbag Sensor Assembly|Page 6028 > < Center Airbag Sensor Assembly|Page 6026