xB L4-2.4L (2AZ-FE) (2009)
/Page-223002.png)
(a) Remove the TURN-HAZ fuse from the engine room relay block.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
(c) Reinstall the TURN-HAZ fuse.
NG -- REPLACE FUSE
OK -- Continue to next step.
2. INSPECT HAZARD WARNING SIGNAL SWITCH
(a) Remove the hazard warning signal switch.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
(c) Reinstall the hazard warning signal switch.
NG -- REPLACE HAZARD WARNING SIGNAL SWITCH
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (HAZARD WARNING SIGNAL SWITCH - MAIN BODY ECU)
