xB L4-2.4L (2AZ-FE) (2009)
(f) Loosen the pulley by turning SST (B) in the direction shown in the illustration.
(g) Remove the generator assembly from the SST.
(h) Remove the clutch pulley from the rotor shaft.
2. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY
(a) Place the generator assembly on the clutch pulley.
(b) Remove the 3 nuts and generator rear end cover.
3. REMOVE GENERATOR TERMINAL INSULATOR
(a) Remove the terminal insulator.
4. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY
(a) Remove the 2 screws and generator brush holder.
5. REMOVE GENERATOR ROTOR ASSEMBLY