xB L4-2.4L (2AZ-FE) (2009)
Axle Beam: Service and Repair
Removal
SUSPENSION: REAR AXLE BEAM: REMOVAL
REMOVAL
1. REMOVE REAR WHEELS
2. DRAIN BRAKE FLUID
NOTICE: Immediately wash off any brake fluid that comes into contact with any painted surfaces.
3. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal
4. LOOSEN WIRE ADJUSTING NUT See: Brakes and Traction Control/Disc Brake System/Service and Repair/Removal and Replacement/Rear
Brake/Removal
5. REMOVE REAR FLOOR SIDE MEMBER COVER LH See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Tank/Service and
Repair/Removal
6. REMOVE REAR FLOOR SIDE MEMBER COVER RH See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Tank/Service and
Repair/Removal
7. REMOVE REAR FLOOR SIDE MEMBER BRACE SUB-ASSEMBLY
(a) Remove the 4 bolts, clamp, and rear floor side member brace sub-assembly.
8. SEPARATE SKID CONTROL SENSOR WIRE (for LH Side)
(a) Using a screwdriver, disconnect the connector from the rear speed sensor.
NOTICE: Be careful not to damage the rear speed sensor.