xB L4-2.4L (2AZ-FE) (2009)
HINT: Perform the same procedure as for the LH side.
6. CONNECT SKID CONTROL SENSOR WIRE (for LH Side) See: Axle Beam/Service and Repair/Installation
7. CONNECT SKID CONTROL SENSOR WIRE (for RH Side)
HINT: Perform the same procedure as for the LH side.
8. INSTALL REAR WHEELS
9. INSTALL REAR FLOOR SIDE MEMBER BRACE SUB-ASSEMBLY See: Axle Beam/Service and Repair/Installation
10. INSTALL REAR FLOOR SIDE MEMBER COVER RH See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Tank/Service and
Repair/Installation
11. INSTALL REAR FLOOR SIDE MEMBER COVER LH See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Tank/Service and
Repair/Installation
12. STABILIZE SUSPENSION See: Axle Beam/Service and Repair/Installation
13. FULLY TIGHTEN REAR AXLE BEAM ASSEMBLY See: Axle Beam/Service and Repair/Installation
14. FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH See: Axle Beam/Service and Repair/Installation
15. FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY RH
HINT: Perform the same procedure as for the LH side.
16. INSPECT REAR WHEEL ALIGNMENT
See: Alignment/Service and Repair/Rear Wheel Alignment
17. CHECK VSC SENSOR SIGNAL
HINT:
See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test
Mode Procedure