xB L4-2.4L (2AZ-FE) (2009)
Clutch Pedal Assembly: Service and Repair
Installation
CLUTCH: CLUTCH PEDAL: INSTALLATION
INSTALLATION
1. INSTALL NO. 1 PEDAL SPRING HOOK
(a) Install the No. 1 pedal spring hook to the clutch pedal support sub-assembly.
2. INSTALL CLUTCH START SWITCH ASSEMBLY
(a) Install the clutch start switch assembly to the clutch pedal support sub-assembly with the nut.
Torque: 16 Nm (160 kgf-cm, 12 ft-lbf)
3. INSTALL CLUTCH SWITCH ASSEMBLY
(a) Install the clutch switch assembly to the clutch pedal support sub-assembly with the nut.
Torque: 16 Nm (160 kgf-cm, 12 ft-lbf)
4. INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS BUSHING
(a) Apply MP grease to the inside of a new clevis bushing.
(b) Install the clevis bushing to the clutch pedal sub-assembly.
HINT: Install the clevis bush from the left side of the vehicle.
5. INSTALL NO. 1 CLUTCH PEDAL CUSHION
(a) Using needle-nose pliers, install the 2 No. 1 clutch pedal cushions to the clutch pedal sub-assembly.
6. INSTALL CLUTCH PEDAL BUSHING