xB L4-2.4L (2AZ-FE) (2009)
8. REMOVE FRONT DRIVE SHAFT DAMPER CLAMP LH
(a) Using a screwdriver, remove the drive shaft damper clamp, as shown in the illustration (for One Touch Type).
(b) Using needle-nose pliers, remove the drive shaft damper clamp, as shown in the illustration (for Claw Engagement Type).
9. REMOVE FRONT DRIVE SHAFT DAMPER LH
(a) Remove the front drive shaft damper from the outboard joint shaft.
10. REMOVE FRONT NO. 2 AXLE OUTBOARD JOINT BOOT CLAMP LH
(a) Using a screwdriver, remove the outboard joint boot clamp, as shown in the illustration.
11. REMOVE FRONT NO. 2 AXLE OUTBOARD JOINT BOOT CLAMP RH
HINT: Use the same procedure as for the LH side.
12. REMOVE FRONT AXLE OUTBOARD JOINT BOOT CLAMP LH
(a) Using a screwdriver, remove the outboard joint boot clamp, as shown in the illustration.
13. REMOVE FRONT AXLE OUTBOARD JOINT BOOT CLAMP RH
HINT: Use the same procedure as for the LH side.
14. REMOVE FRONT AXLE OUTBOARD JOINT BOOT
HINT: Use the same procedure for both sides
(a) Remove the outboard joint boot from the outboard joint shaft.
(b) Remove any old grease from the outboard joint.