–
| Remove rubber retainer from wheelhouse and disconnect connector -1-. |
–
| Remove ABS speed sensor from wheel bearing housing → Item. |
–
| Before fitting the sensor, clean the inner surface of the hole and apply solid lubricant paste → Parts catalogue. |
–
| Install ABS speed sensor. Tighten bolt to specified tightening torque → Item. |
–
| Hook speed sensor cable into brackets and install rubber retainer in wheelhouse. |
–
| Turn steering wheel fully in both directions and check that rev. sensor cable is able to move freely. |
Checking rotor on front axle, removing and installing |
–
| Pull speed sensor out of wheel bearing housing. |
–
| Check that rotor is not damaged or dirty. |
Note t
| If the rotor is soiled or damaged, remove propeller shaft. If damaged, renew outer C.V. joint together with rotor. |
t
| The outer constant velocity joint will be supplied as a spare part together with the rotor → Rep. gr.40. |
|
|
|