Leon Mk2
I - ATF pump up to the large planet gear: general assembly diagram |
1 - | Bolt |
q | 20 Nm |
2 - | ATF pump |
q | Dismantling and assembling → Chapter |
3 - | Gasket |
q | For the ATF pump |
4 - | Brake strap -B2- |
q | Brake for 2nd and 4th |
q | Adjust → Chapter |
q | Place in installation position → Chapter |
q | Place the sprocket pressure bar → Item and adjusting screw → Item into the moulded part of the brake strap |
5 - | Nut |
q | 45 Nm |
6 - | Adjusting screw |
q | For brake strap -B2- |
q | Always renew |
q | Adjusting the brake strap → Chapter |
7 - | Shim |
q | Determine the thickness of the shim by adjusting clutch clearance between -K2- and the ATF pump → Chapter |
8 - | Reverse gear clutch -K2- |
q | Dismantling and assembling → Chapter |
9 - | Axial needle bearing |
q | Note installation position → Chapter |
10 - | Clutch from 1st up to 3rd gear -K1- with turbine shaft |
q | Dismantling and assembling → Chapter |
11 - | Axial needle bearing |
q | Note installation position → Chapter |
12 - | Input shaft |
13 - | Axial needle bearing with washer |
q | Note installation position → Chapter |
14 - | Large planet gear |
15 - | Engine shaft |
q | Dismantling and assembling → Chapter |
q | The corresponding gearbox code is assigned to this spare part |
16 - | Gearbox casing |
17 - | Safety ring |
18 - | Cover |
q | With brake activating piston for 2nd and 4th gears |
19 - | Brake activating piston for 2nd and 4th gears |
q | For brake strap -B2- |
q | The corresponding gearbox code is assigned to this spare part |
20 - | Spring |
21 - | Spring |