Leon Mk2
Slide box (vehicles up to 06.00): removing and installing |
Vehicles from 07.00 onwards → Chapter |
Notes to consider before removing the slide box → Chapter |
1 - | Sealing screw |
q | 15 Nm |
q | Always renew the seal → Fig. |
q | ATF level: checking and topping up → Chapter |
2 - | O-ring |
q | Always renew |
3 - | Solenoid valve -N90- |
q | Grey |
q | Identification → Fig. |
4 - | O-ring |
q | Always renew |
5 - | O-ring |
q | Always renew |
6 - | Solenoid valve -N93- |
q | Pink |
q | Identification → Fig. |
7 - | O-ring |
q | Always renew |
8 - | Solenoid valve -N91- |
q | Blue |
q | Identification → Fig. |
9 - | Support |
q | For the solenoid valves |
10 - | Nut |
q | 9 Nm |
11 - | O-ring |
q | Always renew |
12 - | Solenoid valve -N89- |
q | Yellow |
q | Identification → Fig. |
13 - | Solenoid valve -N88- |
q | Green |
q | Identification → Fig. |
14 - | O-ring |
q | Always renew |
15 - | Bolt |
q | 8 Nm |
16 - | Slide box |
q | Dismantling and fitting → Chapter, Planet gears: dismantling and assembling |
q | Identification → Fig. |
17 - | Manual slide |
q | Secure so that it does not come out when removing the slide box |
18 - | Wiring harness |
q | For the solenoid valves |
19 - | O-ring |
q | Always renew |
q | For the wiring harness connector |
20 - | Connector |
q | For the wiring harness |
q | Remove → Chapter, Planet gears: dismantling and assembling |
q | Engage on fitting to the gearbox casing |
21 - | O-ring |
q | Always renew |
q | Dismantling and fitting → Chapter, Planet gears: dismantling and assembling |
22 - | Gearbox casing |
23 - | Bolt |
q | 9 Nm |
24 - | ATF strainer |
q | To replace, it is necessary to remove the sump and fit it again |
25 - | Magnet |
q | Fit to the sump filler neck |
26 - | Overflow pipe |
q | Remove to let the ATF come out → Chapter, ATF level: checking and filling; Changing ATF |
27 - | Bolt |
q | 8 Nm |
28 - | Sump |
q | Assembly procedure → Chapter, Planet gears: dismantling and assembling |
|
|