Leon Mk2
| Assembly chart -foot pedals |
| 1 - | Support for pedals |
| q | Before dismounting it, dismount the steering column → Drive train, drive axles; Rep. Gr.48. |
| 2 - | Hexagonal bolt, 25 Nm |
| 3 - | Brake light switch |
| q | When dismounting or assembling the switch, press down the brake pedal by hand as far as you can. |
| q | Before dismounting the brake pedal, dismount the switch by turning it 90º to the right and remove it through the assembly opening. |
| q | For its assembly, guide the switch through the assembly opening and fix it into place by turning it 90º to the left. |
| q | Check the working of the brake light. |
| 4 - | Hexagonal self-blocking nut, 25 Nm |
| q | 5 units |
| q | For attaching the pedal support to the servo-brake. |
| 5 - | Clutch pedal switch |
| q | When dismounting or assembling the switch, press down the clutch pedal by hand as far as you can. |
| q | Before dismounting the clutch pedal, dismount the switch by turning it 90º to the right and remove it through the assembly opening. |
| q | For its assembly, guide the switch through the assembly opening and fix it into place by turning it 90º to the left. |
| 6 - | Rubber plug |
| q | Fit it into place in the support for the pedals. |
| 7 - | Housing for neutral overrun spring |
| q | Dismount by turning it to the right. |
| q | Assemble by turning it to the left. |
| 8 - | Neutral overrun spring |
| q | Dismounting and assembling → Chapter. |
| 9 - | Stop for the clutch pedal |
| q | Position for assembly → Chapter |
| 10 - | Dashboard |
| 11 - | Seal |
| q | Always replace |
| 12 - | Flexible tube |
| 13 - | Clutch pump |
| q | Dismounting and assembling → Chapter. |
| 14 - | Hexagonal self-blocking nut, 25 Nm |
| q | Always replace. |
| 15 - | Housing |
| q | Dismount and assemble → Chapter |
| 16 - | Axle for clutch and brake pedals |
| 17 - | Washer |
| 18 - | Bearing sleeve |
| q | For clutch pedal |
| q | Lubricate with -G 052 142 A2- grease |
| 19 - | Clutch pedal |
| q | Dismount and assemble → Chapter. |
| 20 - | Bearing sleeve |
| q | For housing the drive column |
| 21 - | Bearing sleeve |
| q | For brake pedal |
| q | Put it into the bearing sleeve → Item and then put the brake pedal into place. |
| 22 - | Washer |
| 23 - | Hexagonal nut, 25 Nm |
| 24 - | Brake pedal |
