seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Clutch system: bleeding the air > < Dismounting

Leon Mk2

Assembly
Assembly
Perform the operations in the reverse order to those described for the dismounting, taking the following into account:
  Note!
The attachment nuts for the clutch should always be replaced.
Tightening torque: 25 Nm
–  Position for assembly:
   
–  The bead -arrow 1- of the stop for the clutch pedal must be facing towards the clutch pump -B-.
–  The appendage -arrow 2- of the spring housing -C- must remain mounted in the bottom left corner of the part for attaching the pump.
  N30-0268
–  Couple the clutch pedal to the rod for working the clutch pump: To do so, the housing -A- must be put into place on the rod for working -B- the clutch pump.
–  Push the clutch pedal in the direction of the arrow in order to fit the housing over the clutch pedal, make sure that it is fixed into place properly.
–  After the assembly of the clutch pump, bleed the air from the system → Chapter.
  V30-0419

Clutch system: bleeding the air > < Dismounting