SEAT Workshop Service and Repair Manuals

Gear prongs: Repairing Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Pliers -A 81124-, see equivalent → Anchor

t  Kit (case) -U 40300-, see equivalent → Anchor

Identification of commutation pins for gearbox prongs Dimension -a- 1 -  1. and 2nd gear = 11.4 mm 2 -  3. and 4th gear = 7.6 mm 3 -  5. Gear = 6.0 mm

Installation of clamping washers –  Press the spring washer in the groove of the bolt with a handled socket spanner.   Note After installing the spring washer, the commutation bolts must be able to move slightly. A -  Handled socket spanner, e/c 10 mm B -  Protection gags

Removing the inner ring of the ball bearing   Note On removing and installing the inner rings, they do not bend the prongs.

Fit the inner ring of the ball bearing up to the stop.   Note On removing and installing the inner rings, they do not bend the prongs.

prongs with gear commutation bolts installed

Clutch release lever:	Dim.-a- (mm)
1./2. Road speed	88,4 ... 89,1
3./4. Road speed	96,0 ... 96,7

Identification of commutation pins for gearbox prongs → Fig..