Before removing the idler rod, leave the gearbox mechanism in neutral, so that the rod is free.
t
To remove it, separate the selector cable fastener so that the cable is not damaged.
Detach the fastening element from the connection cable
–
Pull the safety mechanism forwards, as far as possible towards -arrow 1-, then block it by turning it to the right, in the direction of -arrow 2-.
–
Then press the idler rod forwards, towards -arrow 3-.
Remove the idler rod
–
Press the spring of deflexion lever wall down with alternating slow and movement forward and back -Arrow- from their inclusion filter. Note, that it does not break.
Remove the fastener on the idler rod
Note
The idler rod must be removed.
–
Place a flat tipped screwdriver-A- between the bushing -B- and the rod, pressing it out until it comes free of the pivot.