Leon Mk2
Clutch release assembly, slave cylinder - Installation overview |
1 - | Clutch release bearing |
q | Do not wash the bearing, clean only |
q | Replace bearings that make noise |
q | Remove and install together with clutch release lever and guide sleeve → Fig. to → Fig. |
2 - | Bolt 5 Nm + 90º |
q | Always replace. |
3 - | Clutch release lever: |
q | Remove and install together with clutch release bearing and guide sleeve → Fig. |
4 - | Fastening spring |
q | Secure to clutch lever |
5 - | Guide sleeve for the clutch release bearing |
q | Remove and install together with clutch release lever and bearing → Fig. to → Fig. |
6 - | Input shaft oil seal: |
q | Replace → Item |
7 - | Knuckle pin 20 Nm |
q | Lubricate with grease, according to → Parts catalogue. |
8 - | Gearbox: |
9 - | Clutch slave cylinder attachment bolts 20 Nm |
10 - | Support |
11 - | Clutch cylinder: |
q | removing and fitting → Chapter |
q | Lubricate the end of the tappet with lubricating grease, according to → Parts catalogue. |
|
|