–
| Loosen oil level test bolt -arrow-. |
Note t
| Oil level is correct when the oil reaches the bottom edge of filling hole. |
t
| The type of bolt depends on the material used to make the gearbox; this may be magnesium or aluminium . Allocation of the corresponding bolt → Parts catalogue. |
–
| If the oil level is not correct, complete oil level. |
–
| Unscrew control lid, start engine and let the gears work with engaged gear for about 2 minutes. |
–
| Stop the engine, remove oil cap and check level again, top up if necessary. |
–
| Tighten the gearbox oil level control cap to a torque of 25 Nm. |
–
| Remove the left soundproofing. . |
–
| Install the medium noise insulation and the left front wheel. |
|
|
|