seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Selection unit: removing and installing > < Sump: removing and installing

Leon Mk2

Oil strainer: removing and installing
Oil strainer: removing and installing
  Note
t  Cleaning norms when working on automatic gearbox → Chapter.
t  General repair instructions → Chapter.
Remove the oil strainer
–  Remove oil sump → Chapter.
   
–  Unscrew the bolts for the oil strainer -arrows-.
–  Remove the oil strainer -A- from the selection unit.
Fit the oil strainer
–  Apply a thin layer of ATF to the gaskets located on the intake collar of the oil strainer (reverse).
  Note
If the gaskets on the reverse of the oil strainer to the selection unit are in bad condition or released from the strainer then the strainer must be replaced.
–  Fit the oil strainer -A- on the selection unit and tighten it.
  A38-0102
ComponentNm
Oil strainer to the selection unit, 3 M6 bolts -arrows-11

–  Fit the oil sump → .
–  Fill ATF, check and correct the ATF level immediately → Chapter.
   

Selection unit: removing and installing > < Sump: removing and installing