–
| Disconnect the 8 pin connector -B- from the gearbox connector. |
–
| Unscrew the attachment bolt from the 8 pin connector on the outer part of the gearbox housing. |
–
| With due care, take out the connector along with the cable harness -C- from the gearbox housing. |
Cable harness with 8 pin connector: fitting |
Installation is carried out in reverse order, noting the following: |
–
| Replace the O-ring on the connector. |
–
| Moisten the O-ring with ATF. |
–
| Press in the connector with the O-ring on the gearbox as far as possible. |
|
|
|