seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Gear knob boot: Removing from the gear knob > < Gear lever knob with cover: Assembly overview

Leon Mk2

Gear lever knob and gear lever cover: Removing and installing
Gear lever knob and gear lever cover: Removing and installing
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Base -T20072A-, see equivalent → Anchor
  L00-10255
t  Lever -U 30800-, see equivalent → Anchor
t  Removing → Anchor
t  Installing → Anchor
Removing
  W00-2169
–  Using the lever -U30800- disconnect the support frame -2-. For this purpose, press the clips in the direction of the -arrows-.
–  Push the retaining tabs -2- upwards -arrow A- and remove from the recesses -1-.
  Note
The gear knob is removed together with the gear lever cover.
  E68-10045
–  Open clamp -1- and remove the gear knob together with the cover and remove the frame of the gear lever.
Installing
Installation is carried out in the reverse sequence; note the following:
–  Fit knob with cover, as far as they will go, onto gear lever.
  E68-10051
–  Secure gear lever knob with a new tightening clamp using the pliers -T20072A-.
  Note
Pay special attention to the measurement of the handle assembly tightening clamp, -A = 4 ± 0.2 mm-.
  E68-10014

Gear knob boot: Removing from the gear knob > < Gear lever knob with cover: Assembly overview