SEAT Workshop Service and Repair Manuals > Leon Mk2 > 0AF 5-speed manual gearbox | Clutch, control | Repair the clutch mechanism | Removing and installing over-centre spring

Installation

Installation is carried out in the reverse order, noting the following:

Note

Grease all of the contact points with the spherical pivot and all the contact surfaces with lubricating grease, according to → Electronic spare parts catalogue „ETKA“.

–	Position clutch pedal over-centre spring -4- on support stand -3-, at the same time lightly pressing upper part of clutch pedal -1- towards master cylinder and against neutral over-centre spring, until bolt can pass through -5- and tighten nut -2- firmly.

–	Install clutch pedal support stand → Chapter.

SEAT Workshop Service and Repair Manuals