t
| O-rings, flanges and gaskets should always be replaced. |
t
| After removing gaskets, check that the contact surfaces of the casing and shaft do not show feathering or damage caused by the removal process. |
t
| Before installing radial seals, apply a little oil to their outer perimeters and fill the space between the sealing lips -arrow-, to half-way, with sealant grease → Electronic spare parts catalogue „ETKA“. |
t
| The open side of the flanges must point towards the liquid to be sealed. |
t
| Fit the new flange in such a way that its sealing lip is not seated in the same place as the lip of the previous flange (taking advantage of the tolerance in the housing depth). |
t
| Before fitting O-rings, lightly lubricate them so that they are not flattened during installation. |
t
| Check oil level after replacing flanges and gaskets. |
|
|
|