Leon Mk2
Input shaft, output shaft (pinion shaft), differential, selector mechanism and selector forks: Assembly overview |
1 - | Differential |
q | Disassembling and assembling |
2 - | Gearbox |
q | Repairing → Chapter |
3 - | Oil drain plug, torque setting → Chapter |
4 - | Flange shaft with compression spring |
q | removing and fitting → Chapter |
q | Assembling |
5 - | 25 Nm conical bolt |
6 - | Bolt, 5 Nm and tighten 90 º more |
q | Self-locking |
q | Always replace. |
q | To secure the allotment with grooved ball bearings for the input and secondary shaft → Item |
7 - | Hexagon flange nut, 23 Nm |
q | Gear selection mechanism → Item |
q | Self-locking |
q | Always replace. |
8 - | O ring |
q | Always replace. |
9 - | Bearing pin |
10 - | Bolt, 5 Nm and tighten 90 º more |
q | Always replace. |
11 - | Selector shaft with selector shaft cover |
q | (Control unit) |
q | Repairing → Chapter |
12 - | Bolt, 5 Nm and tighten 90 º more |
q | Always replace. |
13 - | Bolt, 6 Nm |
14 - | Gearbox neutral position sender -G701 - |
q | For vehicles with start stop system |
15 - | Reversing light switch -F4 -, 20 Nm |
q | Fitted with safety seal just after the gearbox was first mounted as standard |
16 - | Seal |
q | If fitted, always renew |
17 - | Gear selection mechanism |
q | (Selector forks) |
q | Repairing → Chapter |
18 - | Input shaft and output shaft with bearing mounting and deep groove ball bearing |
q | Replace the allotment whenever it detaches from the gearbox casing |
q | Remove and install the bearing mounting: Disassembly and assembly of the input shaft → Item |
q | Disassembly and assembly of the input shaft → Chapter |
q | Disassembly and assembly of the secondary shaft → Chapter |
19 - | Reverse gear pinion axis |
20 - | Reverse gear wheel |
21 - | Bolt, 25 Nm and tighten 90 º more |
q | Always replace. |
q | To fasten reverse gear pinion axis |
22 - | Oil collector |
23 - | Magnet |
24 - | Oil guide |