Leon Mk2
| Removing and installing differential and freewheel lock |
| Parts → Item, → Item, → Item through → Item, → Item only on rear final drive with freewheel. |
| 1) | Adjustment work is required if these components are renewed, adjustment overview → Chapter. |
| 1 - | Rear axle housing → Note |
| 2 - | O-ring |
| q | Always renewing. |
| 3 - | Mounting bolt for selector lever, 55 Nm |
| 4 - | Plug, 55 Nm |
| 5 - | Selector lever for lock/freewheel |
| q | Installation position → Anchor. |
| 6 - | Oil drain plug, 25 Nm |
| q | With magnet. |
| 7 - | Oil filler plug, 25 Nm |
| q | Capacity and specification → Chapter. |
| q | Checking gear oil in rear final drive → Chapter. |
| 8 - | O-ring |
| q | Always renewing. |
| 9 - | Complete differential without freewheel |
| q | Removing with cover → Anchor. |
| q | Pressing in with cover → Anchor. |
| q | Dismantling and assembling differential → Chapter. |
| 10 - | Hexagon bolt, 25 Nm |
| 11 - | Flange shaft |
| q | Removing → Anchor. |
| q | Driving in with plastic hammer. |
| 12 - | Circlip |
| q | Always renewing. |
| q | Removing and installing → Chapter. |
| 13 - | Complete differential with freewheel |
| q | Removing with cover → Anchor. |
| q | Pressing in with cover → Anchor. |
| q | Dismantling and assembling differential → Chapter. |
| q | Checking function of freewheel (on vehicle) → Chapter. |
| 14 - | Compression spring |
| q | Inner diameter 46 mm. |
| q | With lock switched off, holds locking collar away from selector pin. |
| q | Installation position → Anchor. |
| 15 - | Sliding sleeve |
| 16 - | Balls (qty. 6) |
| q | Insert with high-viscosity grease. |
| q | Installation position → Anchor. |
| 17 - | Compression spring |
| q | Inner diameter 64.5 mm. |
| q | With lock switched off, holds retainer for balls. |
| q | Installation position → Anchor. |
| 18 - | Locking collar |
| q | Installation position → Anchor. |
| 19 - | Breather sleeve |
| q | Installation position → Fig.. |
| 20 - | Freewheel lock control element |
| q | Controls freewheel lock electro-pneumatically. |
| q | Removing: unbolt, turn 90° downwards and remove. |
| q | Installing → Anchor. |
| q | Checking function → Chapter. |
| q | Use only cold cleansing agents to clean and seal connections. |
| 21 - | Hexagon bolt, 15 Nm |
| 22 - | Cover |
| 23 - | O-ring |
| q | Always renewing. |
|
|
