seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Torque settings > < Renewing flange shaft or drive flange oil seals (final drive installed)

Leon Mk2

Renewing oil seal for right flange shaft
Renewing oil seal for right flange shaft
–  Unbolt drive shaft and tie up.
   
–  Remove flange shaft, to do this screw in 2 bolts -A- on alternate sides.
A - Bolts M 10 x 100
–  Lever oil seal out using assembly lever.
  V39-1949
–  Drive in new oil seal to stop.
Half-fill space between sealing lip and dust lip with grease -G 052 128 A1-.
–  Clamp flange shaft in vice with protective jaw covers.
  N39-0627
–  Use new circlip -A- to press old circlip out of groove in flange shaft.
–  Drive in flange shaft using a plastic headed hammer.
–  Renew flange shaft/drive shaft seal (pull off protective foil and glue seal into joint).
–  Reconnect drive shaft flanges.
–  Check rear final drive oil → Chapter.
  V34-2005

Torque settings > < Renewing flange shaft or drive flange oil seals (final drive installed)