Removing and installing “G93” |
Sender “G93” cannot be separated from the wiring harness. |
–
| Remove bearing and differential cage. |
Then the cover must be removed. |
Warning Do not turn back gearbox before cover is reinstalled. |
Otherwise, clutch “K2/K3” and other components will fall out. |
|
–
| Unbolt wiring harness retainer. |
–
| Unbolt “G93” and remove. |
–
| Guide wire for sender “G182” from beneath through gearbox housing. |
–
| Push on connector, install sender “G182” and tighten bolts to 8 Nm. |
–
| Install “G93” and tighten bolts to 8 Nm. |
–
| Push on connectors for “G68” and “G265”. |
–
| Install wiring harness retainer and tighten bolt to 8 Nm. |
–
| Guide wiring into valve body housing. |
|
|
|