SEAT Workshop Service and Repair Manuals

Removing and installing mounting bracket with clutch pedal and master cylinder

Special tools and workshop equipment required

t	Choke clip for hoses -3094-

t	Torque wrench -V.A.G 1331-

t	Not required, spring-type clip pliers -VAS 5024 A-

Sealing tool -T10249- Removal:

–  Using hose clamp -3094-, clamp off supply hose to master cylinder.   Note t  During the following work, ensure that no brake fluid lands on longitudinal member or gearbox. If this does happen, clean the affected areas thoroughly. t  Lay a lint-free cloth under master cylinder. t  When performing work in the footwell, put cloths on the carpet to protect it from possible brake fluid spills.

–  Disconnect supply hose -1- from master cylinder. –  In addition, for disconnecting, it can be closed with the sealing tool -T10249/1- (⇒ figure above). –  Release securing clip -2- to stop using screwdriver or a pointed object and disconnect pipe -3- from master cylinder. –  Remove driver side footwell cover → General body repairs, interior; Rep. gr.68. –  If fitted, remove clutch pedal switch -F36- → Chapter.

–  Remove the crash bar, screw -1-. Observe the nut -2-.

Vehicles with start/stop system: –  Unclip clutch position sender -G476- from master cylinder -arrow A- and remove from fitting location -arrow B-. –  Remove clutch position sender with electrical connector connected.

Continuation for all vehicles –  Unscrew securing nuts. –  Remove mounting bracket.

Installation Installation is carried out in the reverse sequence; note the following:   Note Renew self-locking nut. –  Tighten securing nuts → Item.

–  Install the crash bar, screw -1- → Item. Observe the nut -2-. –  If fitted, install clutch pedal switch -F36- → Chapter.

Vehicles with start/stop system: –  Fit clutch position sender -G476- on master cylinder into fitting location -arrow B- and clip it in -arrow A-. –  Test clutch position sender by tugging on it. Continuation for all vehicles –  Install driver side footwell cover → General body repairs, interior; Rep. gr.68.

–  After removing hose clamp -3094-, supply hose -1- must be returned to its original position and shape. –  Press pipe -3- in to stop at connection of master cylinder until securing clip -2- audibly engages. –  Test line by tugging on it. –  Purging the clutch control → Chapter