Leon Mk2
| Removing and installing cover for Haldex coupling and plates |
| 1 - | Hexagon nut, 220 Nm |
| q | Unscrewing and screwing in → Chapter. |
| q | Insert with locking fluid -D 000 600- |
| 2 - | Propshaft flange |
| q | Pulling off |
| 3 - | Hexagon bolt, 50 Nm |
| 4 - | Oil drain plug, 15 Nm |
| q | For Haldex coupling oil |
| 5 - | Seal |
| q | Always renew |
| 6 - | Haldex coupling cover |
| q | Remove together with plate housing |
| q | To install, separate from plate housing → Anchor |
| 7 - | O-ring |
| q | Always renew |
| q | Moisten with high-performance oil for Haldex coupling |
| 8 - | Ring |
| q | Insert in pinion housing |
| 9 - | Roller |
| q | Qty. 3 |
| 10 - | Wheel roller |
| q | Qty. 6 |
| 11 - | Cam disc |
| q | Observe installation position → Anchor |
| 12 - | O-ring |
| q | Qty. 3 |
| q | Always renew |
| q | Insert in Haldex coupling cover |
| 13 - | Seal |
| q | Always renew |
| q | O-rings may also be installed in some final drives → Chapter, fig. N01-0234 |
| 14 - | Four-wheel drive control unit -J492- |
| q | Removing and installing → Chapter |
| 15 - | Socket head bolt, 6 Nm |
| 16 - | Set of plates |
| q | Observe installation position of outer and inner plates → Anchor |
| 17 - | Hub |
| 18 - | Thrust washer |
| q | Observe installation position → Anchor |
| 19 - | Needle thrust bearing |
| q | With thrust washer for needle thrust bearing |
| q | Installation position → Anchor |
| 20 - | Haldex coupling pump -V 181- |
| q | Removing and installing → Chapter |
| 21 - | Socket head bolt, 6 Nm |
| 22 - | Seal |
| q | Always renew |
| 23 - | O-ring |
| q | Always renew |
| 24 - | O-ring |
| q | Always renew |
| 25 - | Pinion housing |
| q | → Item |
